The motorbike tracker is divided into wired and unwired. The installation of the electric vehicle positioner requires a certain number of steps (described below). The unwired electric vehicle positioner does not need to be installed, and is placed directly under the electric vehicle seat or the vehicle. A place where it can adsorb (with iron). It is worth noting that attention should be paid to the concealment during installation to achieve good results in positioning theft. Next, look at how to install the electric vehicle positioner.
Tools to be prepared before installation: Phillips screwdriver, scissors, universal meter, insulating tape, foam tape, nylon cable tie, waterproof bag
1. Unscrew the screw on the outer plastic baffle of the electric vehicle line console. After unscrewing the screw, remove the plastic baffle and you will see the line console.
Second, find the dedicated external interface in the line (or strip the line yourself, find the constant power line), measure the voltage with a universal meter, and observe whether it meets the rated voltage of the equipment.
3. Connect the equipment to the selected constant power line and connect the orange ACC line of the equipment to the ACC line of the electric vehicle. (The ACC line is to open the electric door and turn off the electric circuit.)
4. After connecting the ACC cable and turning on the device switch, you can see that the device indicator lights up, indicating that the device has started working.
Where the electric vehicle locator device is, directly affects what effect it will reach. If the electric vehicle positioner is installed in the wrong position, not only the alarm effect will not be achieved, but also the disassembly of the reinstallation device will take a lot of effort. Therefore, the location of the device is the first. When the device is positioned, the host must have the device in the center of the power cord. In addition, the location of the device must be easy to route, and the wireless locator host can be installed at the center of all detectors to facilitate signal reception and prevent bad channel conditions.
The installation of the electric vehicle positioner is basically the above. The place to pay attention to is that the electric vehicle positioner wiring is correct, as well as the position and concealment of the installation. Be sure to read the above introduction when loading. If you don’t understand the line, please choose a regular manufacturer.
Post time: Aug-22-2019